Xtra Smileys
[Open]
Flame Damnation
August 22, 2019, 03:01:05 am
Welcome, Guest. Please login or register.

Login with username, password and session length
News:   
 
 
  Home Help Arcade Gallery Links Login Register  

I'm Too Weak to Post


Pages: [1]   Go Down
  Reply  |  New Topic  |  Print  
Author Topic: I'm Too Weak to Post  (Read 72 times)
caskur
Swing Voter
Administrator
Hero Member
*****
Offline Offline

Posts: 11001


Tortured Artist


« on: December 07, 2008, 09:00:32 am »
Reply with quoteQuote

I'm not shaking off my pneumonia as quick as I would, a cold.

I feel too weak to post so I am sorry I can't.


 Angry

Report Spam   Logged

Damion Hellstrom
Guest
« Reply #1 on: December 07, 2008, 11:53:41 am »
Reply with quoteQuote

You should go see the doctor again.
Report Spam   Logged
rsh
Full Member
***
Offline Offline

Gender: Female
Posts: 236



« Reply #2 on: December 07, 2008, 12:56:15 pm »
Reply with quoteQuote

Get your rest!

I had pneumonia a couple of years ago - it was a long recovery time.

Hope you feel better soon!
Report Spam   Logged
caskur
Swing Voter
Administrator
Hero Member
*****
Offline Offline

Posts: 11001


Tortured Artist


« Reply #3 on: December 07, 2008, 04:30:39 pm »
Reply with quoteQuote

Get your rest!

I had pneumonia a couple of years ago - it was a long recovery time.

Hope you feel better soon!

My eye is fixed. The anti-biotic eye drops worked from the first application.

I have two days anti-biotic left.....I'll get some more if I need them and I'm thinking I am going to.
Report Spam   Logged
caskur
Administrator
Hero Member
*****
Offline Offline

Posts: 1590



« Reply #4 on: December 07, 2008, 05:30:55 pm »
Reply with quoteQuote

Get well soon.

This board has been quiet.

Where the hell has Voltage got to?
Report Spam   Logged

arete
Guest
« Reply #5 on: December 19, 2008, 08:39:48 pm »
Reply with quoteQuote

Hope you are feeling much better soon, miss THANG.
Take lots of echinacea & vitamin C & all that good stuff.
Report Spam   Logged


Pages: [1]   Go Up
  Reply  |  New Topic  |  Print  
 
Jump to:  

Bookmark this site!
Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy